Extruder cable water blower for 6mm diameter

Extruder cable water blower for 6mm diameter

Specifications and models

1. A single-stage ordinary water blower with an inner hole of 3mm-200mm

2. Single section with ceramic eye water blower-inner hole 3mm-30mm

3. The inner hole of the two-stage ordinary water blower is 3mm-200mm

4. The inner hole of the double section with ceramic eye water blower is 3mm-30mm

5. Three-stage ordinary water reservoir 3mm-200mm

6. Three sections with ceramic eye water blower 3mm-20mm

Working conditions and selecting model

1. The air compressor displacement cannot be lower than 0.6 cubic/min, and the air supply pressure cannot be lower than 0.55mpa.

2. Air compressor selection: air compressor oil screw type and piston type, it is generally recommended to choose screw type air compressor. Two air compressors power cannot be lower than 55-75 (KWP)

3. Selection of water blower: maximum wire diameter X1.5-2 times = the inner hole of the water blower actually needs to be purchased, the coefficient is not fixed. Adjust appropriately according to actual usage. If the inner hole is too large, it will waste gas and the effect is not good. If the inner hole is too small, it will scratch the line. The knots and drums cannot pass smoothly.

If you want to know more about the use of water blower selection, air compressor air pressure, exhaust volume, etc., please consult customer service

Extruder cable water blower for 6mm diameter